NaN_3对玉米萌发过程中超弱光子辐射的影响

为了解读植物种子萌发过程中超弱光子辐射信息的生物学意义,采用呼吸抑制剂NaN3处理萌发玉米种子,跟踪测量和分析了玉米种子萌发过程中超弱光子辐射中自发光子辐射和外界光诱导的延迟光子辐射的变化规律,同时研究了萌发玉米种子鲜质量的变化.结果发现,NaN3同步抑制了萌发玉米自发光子辐射和鲜质量的增长,造成萌发玉米延迟光子辐射的初始光子数和延迟光子辐射积分强度大幅度降低,相干时间减小.机理分析表明,NaN3对呼吸代谢电子传递链的抑制造成的自由基反应减弱是萌发玉米自发光子辐射减小的原因,自发光子辐射强度可以作为玉米萌发状态的信号,延迟光子辐射动力学参数的大小可以表征萌发玉米呼吸代谢的强弱,相干时间是种子细胞组织序性的量度,通过对萌发种子超弱光子辐射的采集和分析可以实现对萌发种子细胞代谢和功能状态变化的灵敏和无损检测.     

Surface strain-field determination of tympanic membrane using 3D-digital holographic interferometry

In order to increase the understanding of soft tissues mechanical properties, 3D Digital Holographic Interferometry (3D-DHI) was used to quantify the strain-field on a cat tympanic membrane (TM) surface. The experiments were carried out applying a constant sound-stimuli pressure of 90 dB SPL (0.632 Pa) on the TM at 1.2 kHz. The technique allows the accurate acquisition of the micro-displacement data along the x, y and z directions, which is a must for a full characterization of the tissue mechanical behavior under load, and for the calculation of the strain-field in situ. The displacements repeatability in z direction shows a standard deviation of 0.062 µm at 95% confidence level. In order to realize the full 3D characterization correctly the contour of the TM surface was measured employing the optically non-contact two-illumination positions contouring method. The x, y and z displacements combined with the TM contour data allow the evaluation its strain-field by spatially differentiating the u(m,n), v(m,n), and w(m,n) deformation components. The accurate and correct determination of the TM strain-field leads to describing its elasticity, which is an important parameter needed to improve ear biomechanics studies, audition processes and TM mobility in both experimental measurements and theoretical analysis of ear functionality and its modeling.     

基于ARM的嵌入式超声传播时间测量装置

应用超声波检测技术进行检测时,通常需对超声波在介质中的传播时间进行精准的测量,为精准测量超声波的传播时间,设计了一套基于ARM的嵌入式超声传播时间测量装置。该装置电路运行稳定,成本低廉,采用多次测量结果取算数平均值的方法以减小随机干扰,采用参比方法放置接收探头以消减电路中电子器件的延时。通过对实验结果进行分析,得出该装置可精准测量超声波在实验试块中的传播时间且满足设计要求,分辨率可达一纳秒。     

单矢量水听器估计目标方位的方法与实验

为评估基于单矢量水听器的方位估计能力,在黄海海域对矢量水听器进行实验。矢量水听器吊放于接收船尾部,采用平均声强器和复声强器方位估计方法,并提出以概率密度值最大的方位角作为目标方位估计值的具体处理准则,对恒定方向、匀速行驶的目标船方位进行估计,并求出两种方法的方位估计误差。结果表明,水听器布放深度10 m时,对正横距离为0.42 km的航速10 kn的目标船,平均声强器方法的水平方位角估计误差18°,极角估计误差为5°,可以在离目标船最远1.17 km处估计其方位;复声强法的水平方位角估计误差为13°,极角估计误差为8°,可以在离目标船最远2.35 km处估计其方位。在有接收船的噪声干扰情况下,复声强器比平均声强器方法估计的方位更准确,可以对更远处的噪声源进行方位估计。     

Identifying mode shapes and modal frequencies by operational modal analysis in the presence of harmonic excitation

Operational modal analysis techniques allow us to extract the modal properties of structures based on their response to non-measured stationary white noise, i.e., by considering only the system response to operational excitations. In this paper we outline a procedure to deduce modal parameters from operational response measurements. In particular, we discuss a novel approach to analyze operational responses due to unknown harmonic excitation in addition to noise. Structural eigenfrequencies and modal damping are computed using a modified least-squares complex exponential method. Once the poles of the system are identified, mode shapes are obtained by post-processing. The robustness and accuracy of the approach are illustrated by performing tests on a plate structure.     

Dynamic and Quasi-Static Propagation of Compaction Waves in a Low-Density Epoxy Foam

We conducted dynamic and quasi-static compression experiments with low-density (ρ = 120 kg/m³) epoxy foam specimens. The specimens had a 10.0-mm-square cross-section and a length of 19.3 mm. Dynamic experiments were conducted with a modified split Hopkinson pressure bar (SHPB), and the quasi-static experiments were conducted with a hydraulic load frame device (MTS-810). In both cases, the specimens were loaded from one end at a constant velocity. Equally spaced grid lines were marked on the specimens to monitor the deformation history. Digital images taken at equally spaced time intervals gave the positions of each grid line. These images showed that a constant end-face velocity V produced a compaction wave front that traveled at a constant velocity C in both dynamic and quasi-static experiments. We described these results with a shockwave analysis that used a locking solid material model.     

软岩流变的一种新的试验研究方法

 研制了用于软岩流变的蠕变-松弛耦合试验仪，探讨了利用单级 加载和逐级加载两种方式确定软岩流变参数和长期强度的蠕变-松弛耦 合试验原理. 有关的具体试验表明，该仪器操作简便, 稳定性好，所得 结果客观、可靠，可在工程中推广应用.     

无条件稳定数值积分方法在拟动力实验中的应用研究

用无条件稳定的隐式α－方法代替目前的条件稳定的显式方法，通过数值迭代控制方法实现了拟动力实验．在此基础上进一步应用子结构技术，解决了刚度大、自由度较多结构采用传统的条件稳定数值积分方法进行拟动力实验的问题．应用不同数值积分方法进行的三层模型结构的实验结果表明，无条件稳定的数值积分方法的实验精度优于条件稳定的数值积分方法的精度．文中还就实验误差的控制补偿问题进行了讨论，提出了采用瞬时割线刚度进行补偿的方法     

外环干扰力矩对陀螺加速度计测试精度的影响

摆式积分陀螺加速度计的外环干扰力矩包括仪表外环轴的摩擦力矩和交叉轴加速度引起的交变力矩。作者分析了引起摆式积分陀螺加速度计外环干扰力矩的主要原因,提出一种在高精度三轴测试转台上分离摆式积分陀螺加速度计外环干扰力,测试摆式积分陀螺加速度计精度的试验方法。该试验采用三轴转台中环转动速度随动摆式积分陀螺加速度计外环进动角速度,同时摆式积分陀螺加速度计陀螺摆的输出轴在整个试验中保持水平,从而分离仪表外环干扰力的方案。通过对试验数据进行分析,得出外环干扰力的存在影响了摆式积分陀螺加速度计测试精度,为改善摆式陀螺加速度计工艺以提高摆式陀螺加速度计的测试精度提供了依据。     

A variational solution of 2-D sound-structure interaction problems

Based on the fluid-structure coupling theory, a localized variational principle for analyzing the sound radiation from elastic structure submerged in water due to harmonic excitations is presented. It will be a powerful tool to formulate various numerical methods for steady response of structural-acoustic systems. By means of this variational principle a hybrid element method, in which an analytical solution valid in most of the surrounding water is incorporated with finite elements distributed in the structure and its neighboring water, is devised. Computational examples are then given to demonstrate its high accuracy and time saving. The project supported by the National Natural Science Foundation of China (10172038) and the Doctoral Program Foundation of Institution of Higher Education of China (20040487013). The English text was polished by Yunming Chen.